NES Toploader Mini Din RGB Replacement Rear Panel 3D Printed No Reduce Mod


I got the thought to do this unique back panel when I saw some posts from Voultar. I picked of some of the readily readily available eight Pin Mini Dins that are meant to be PCB mounted and decided to appear for a resolution to mounting them. I sent a functioning unit off to Voultar to test out, and he was impressed by it.

This rear panel cover comes in 3 versions
Only Mini Din
Mini Din plus palette switch
Mini Din plus trss jack

The mini din is held in with a uncomplicated slide on U shaped clip, producing it simple to set up the din immediately after wiring it up.

This is not a new thought for replacement back covers, numerous Multiout style covers exist currently, I am even functioning on a further a single to add to that pile. hopefully this aids folks who have to have a mini din rather for their setups.

In addition to the printed components you will have to have some further components

Mini din Search for Mini eight Pin Circular DIN Connector
five.5×2.1mm barrel jack to match the NES search for 5.5×2.1mm pcb two pin the side pin can be lifted and reduce off to make them perform
Palette switch search for 2 Position Terminal SPDT Latching Mini Toggle Switch
TRRS Jack search for 3.5mm trrs jack panel mount and get a single that has a hex nut to match the element

Print with the top rated to the bed, it will have to have supports for the screw holes and for the square energy hole, but nothing at all big.

3D Print files can be downloaded right here:

Pre-Produced Versions can be purchsed from the principal shop at:


Mini eight Pin Circular DIN Connector


Latest posts